• Foundations
• Floors
• Walls
• Columns
• Ceilings
• Roofs

• Foundation
• Floor structure
• Wall structure
• Columns
• Ceiling structure
• Roof structure.

• Wall cladding, flashings and trim
• Entryway doors and representative number of windows
• Garage door operators
• Decks, balconies, stoops, steps, areaway and porches, including railings
• Eaves, soffits and fascias
• Vegetation, grading drainage, driveways, patios, walkways and retaining walls with respect to their effect on the condition of the building

• Roof coverings
• Roof drainage systems
• Flashing
• Skylights
• Chimneys
• Room penetrations

• Interior water supply and distribution system including:
• Piping materials including supports and insulation
• Fixtures and faucets
• Functional flow
• Leaks
• Cross connections
• Interior drain, waste and vent system including:
• Traps; drain, waste and vent piping; piping supports and pipe insulation
• Leaks
• Functional drainage
• Hot water systems including:
• Water heating equipment
• Normal operating controls
• Automatic safety controls
• Chimneys, flues and vents
• Fuel storage and distribution systems including:
• Interior fuel storage equipment, supply piping, venting and supports
• Leaks
• Sump pumps

The Inspector shall describe:

• Water supply and distribution of piping materials
• Drain, waste and vent piping materials
• Water Heater Equipment

• Service entrance conductors
• Service equipment, grounding equipment, main over current device, main and distribution panels
• Amperage and voltage ratings of the service
• Branch circuit conductors, their over current devices, and the compatibility of their ampacities and voltage
• The operation of a representative number of installed lighting fixtures, switches and receptacles located inside the house, garage and on it’s exterior walls
• The polarity and grounding of all receptacles within six feet of interior plumbing fixtures, and all receptacles in the garage or carport and on the exterior of inspected structures.
• The operation of ground fault circuit interrupters

• Service amperage and voltage
• Service entry conductor materials
• Service type as being overhead or underground
• Location of main and distribution panels

• Heating equipment
• Normal operating controls
• Automatic safety controls
• Chimneys, flues and vents
• Solid fuel heating devices
• Heat distribution systems including fans, pumps, ducts and piping with supports, dampers, insulation, air filters, registers, radiators, fan-coil units convectors
• The presence of an installed heat source in each room

• Energy source
• Heating equipment and distribution type

• Central air conditioning
• Normal operating controls
• Cooling and air conditioning equipment

• Distribution systems
• Fans
• Pumps
• Ducts
• Piping with supports
• Dampers insulation
• Air filters
• Registers
• Fan-coil units

• Walls, ceilings and floors
• Steps, stairways, balconies and railings
• Counters and a representative number of cabinets
• A representative number of doors and windows
• Separation walls, ceilings and doors between a dwelling unit and an attached garage or another dwelling unit.
• Sumps

• Operate a representative number of primary windows and interior doors
• Report signs of water penetration into the building or signs of abnormal or harmful condensation on building components

• Insulation and vapor retarders in unfinished spaces
• Ventilation of attics and foundation areas
• Kitchen, bathroom and laundry venting systems

• Insulation and vapor retarders in unfinished spaces
• Absence of same in unfinished space at conditioned surfaces

• Smoke detectors
• Carbon monoxide detectors
• Cooking ventilation
• Fence and gate
• Child safety
• Clothes dryer vent

• Cook top
• Oven
• Dishwasher
• In sink disposal

• General overall construction
• Plumbing
• Safety railing and fence
• Filter and pump installation
• Grounding of fixtures
• Grounding of electrical systems
• Lighting in the pool or spa
• GFI protection
• Door and fence alarms
• Drainage systems around walk area
• Fill and empty systems
• Visible leaks or cracks
• Heater operation and venting safety valves

Tests We Provide At An Additional Charge:
(Lab Testing May Be Required)

• Termite
• Radon
• Mold
• Lead Paint
• Water (Basic)
• Pool and Hot Tub

Please call regarding inquiries pertaining to other testing.

• Infrared Thermography Inspections
• Energy Audits

Using infrared technology our experienced technicians can detect any hot or cold spots which can indicate energy leaks. By seeing where the leaks and correcting them you can save on your energy bills.